1. Using the longer T-knobs, attach "A" marked legs to the table bottom about half way along the slot / track ..... toothed wheel of each leg should face away from each other & not towards each other
2. Attach, using the shorter T-knobs, a leg "B" to each leg "A"
3. Use the alignment markers near the shorter T-knobs & on leg "B" to lock each leg at the same angle. Typically, when locked between the two longer markers the table is comfortable to work with.
4. Place a laptop on the table and lift combination over yourself (while in a reclined position). Adjust height and angle until your fingertips reach the keyboard with your elbows on the bed.
5. Move the grey stoppers / ledges along the bottom edge of the table until they are not in the way of front edge ports or controls. Tighten snugly at this location.
Attach, using the shorter T-knobs, a leg "B" to each leg "A"
Use the alignment markers near the shorter T-knobs & on leg "B" to lock each leg at the same angle.
Typically, when locked between the two longer markers the table is comfortable to work with.
While in a reclined position, adjust height and angle until your fingertips reach the keyboard with your elbows on the bed.
Easy Assembly|
